Maintenance Schedule; Daily Maintenance; Weekly Maintenance - Husqvarna 326HS75X series Operator's Manual

Carb ii, epa ii
Hide thumbs Also See for 326HS75X series:
Table of Contents

Advertisement

MAINTENANCE
Maintenance
schedule
Below you will find some general mair_termnce instructions.
Daily maintenance
• Check throttle trigger and throttle trigger lockout function.
• Check stop switch function.
• Check that the blades do not rotate while idling or when the
choke is in the start position.
• Clean the exterior of the machine.
• Check that the harness is undamaged.
• Check that the blade is properly centred, sharp, and without
cracks.
• Check the hand guard for cracks and chips or damage.
Replace if necessary.
• Check that tile blade screws are sufficiently
tightened
(See
the section
"Control, maintenance and service of the machine's
safety equipment _).
• Make sure that the blade transport
guard is undamaged
and
that it can be securely fitted.
• Check that nuts and screws are sufficiently
tightened.
• Check for fuel leaks.
Weekly
maintenance
• Check the starter, especially cord and return spring.
• Make sure that the vibration damping
elements are not
damaged.
• Clean tile carburetor
area.
• Clean the exterior of the spark plug.
• Remove it and check the electrode gap.
• Adjust it to 0,5 mm (.020"), or change the spark plug.
• Clean the cooling fins on the cylinder and check that the air
intake at the starter is not clogged.
• Fill the gearbox with grease. This should be carried out after
approximately
every 20 working hours.
• Clean tile air filter.
• Clean or replace the muffler's spark arrest screen (not on
mufflers with a catalytic converter).
Monthly
maintenance
• Clean the fuel tank.
• Clean tile exterior of the carburetor
and the space around it.
• Clean the fan and the space around
it.
• Check fuel hose for cracks or other damage. Change if
necessary.
• Change fuel filter in fuel tank.
• Check clutch, clutch spring and clutch drum for wear.
Change if necessary.
• Check electrical wires and connections.
• Change tile spark plug.
• Change the airfilter.
• Check and clean the muffler's spark arrest screen if necessary
(only mufflers with a catalytic converter).
1 8 - EngEish

Advertisement

Table of Contents
loading

This manual is also suitable for:

326hs99x series

Table of Contents