Table of Contents
Advertisement
START AND STOP
Control before starting
•
Inspect
the working
area. Remove
objects
that
can be
thrown.
•
Check
the blades.
Never
use blades
that are dull,
cracked
or damaged.
•
Check
that
the hedge
trimmer
is in full
working
order.
Check
that
all nuts and bolts
are
tightened
correctly.
• Make sure the gearbox is lubricated
correctly. See the
section "Lubricating
the bladed'.
• Ensure the blades always stop when tile engine is idling.
•
Only use the machine for what it is intended
for.
• Ensure that the handle and safety functions are in order.
Never use a machine
that lacks a part or has been modified
outside of the specifications.
Start and stop
Start
Cold engine
IGNITION:
Set the stop switch to the
start position.
CHOKE:
Set the choke
control
in the
choke
position
(A).
The choke
position
is also
the automatic
start throttle
position.
AIR PURGE:
Press the air purge
diaphragm
repeatedly
until
fuel begins
to fill the
diaphragm.
The
diaphragm
need
not be completely
filled.
@
A
Warm engine
IGNITION:
Set the stop switch to the
start position.
CHOKE:
Set the choke control in the
choke position and then
back again to its original
position
(B)
In this way only the start
throttle is applied with no
choke.
AIR PURGE:
Press the air purge
diaphragm
repeatedly
until
fuel begins to fill the
diaphragm.
The diaphragm
rmed not be completely
filled.
@
Press the machine body
against the ground using your
left hand
(NOTE! Do not
use
your foot). Grip the starter
handle with your right hand
and slowly pull the starter
cord out until you feel some
resistance,
(the starter hooks
grip) now quickly and
powerfully pull the cord.
Immediately
press the choke
control in when the engine
fires and repeat until the
engine starts. When the
engine starts, quickly apply
full throttle and the start
throttle will automatically
disengage.
@
NOTE! Do
not pull the starter cord out completely
and do
not release the starter cord from the fully extended
position.
This can damage the hedge trimmer.
Stop
The engine is stopped by
switching the ignition off
using the stop switch.
English - 1
3
Advertisement
Table of Contents
