2. Remove (2) screws located at front of turbine.
3. Disconnect hose from turbine and lift out of
position.
K. Pump
1. Remove
(1) screw located on pump
doghouse.
2. Release tab with flat blade screwdriver
from
bottom of unit (Fig. 18).
Fig. 18
3. Disconnect
hoses from pump.
L. Motor CoverNalve
Assembly
1. Remove standpipe seal.
2. Remove (6) screws (Fig. 19)
3. To lift out of position flex outer walls of main
body to clear tabs.
4. Feed tubes through motor cover and remove.
M. Motor
1. Remove
hood.
2. Remove
recovery tank duct.
3. Remove
hose connection
at valve.
4. Remove valve lever.
5. Remove turbine assembly.
6. Remove motor cover/valve
assembly.
7. Disconnect
all lead wires.
8. Lift motor out of position.
Note:
Motor is replaced
as an assembly
only.
N. Attachment
Cord
1. Disconnect all lead wires.
2. Remove strain relief from underneath unit by
squeezing tabs and pushing through housing.
Note:
Upon reassembly, route cord as shown in
Fig. 20. Also, it is very important
to reconnect
the ground lead.
Fig. 19
Fig. 20