Checking The V-Belts; Deck Belt - Husqvarna Z4824 Operator's Manual

MAINTENANCE
Checking the V-belts
WARNING!
No adjustments or maintenance to be carried out unless:
• The engine is stopped.
• The ignition key has been removed.
• The parking brake is on,
Deck belt
V-belts are not adjustable. Replace belts if they begin to slipfrom wear.
Deck belt removal
WARNING!
Idler arm is spring loaded. Have
a tight grip on idler arm or
ratchet and release slowly,
Park on a level surface. Apply parking
brake.
Lower the deck into the lowest cutting
position
Disengage belt tension by pushing
inward on deck belt idler pulley by hand
or with a 1/2" ddve ratchet placed in
square drive hole on idler arm, While arm
is pushed inward, remove belt from
stationary idler pulley and release idler
arm slowly until spdng force is no longer
felt.
Remove bolt from idler pulley. This will
allow belt to pass by the belt guide.
Loosen screws from both left and dght
plastic belt shield above each mandrel
housing. Remove shields
Remove any dirt or grass that may have
accumulated around the cutter housings
and entire deck surface.
Carefully roll the belt over the top of the
cutter housing pulleys.
Remove the belt from around the electric
clutch on the engine shaft.
The belt can now be removed.
English_42