Operation - HAMPTON BAY Room Air Conditioners Installation & Operation Manual

I1
8. CONTROL PANEL
One of the pictured control
,anels is similar to your panel.
MASTER CONTROL
5 a
2_._ _ " 9
THERMOSTAT
MASTER CONTROL
oF_
...._ %ooLY
THERMOS_rAT
Caution: If air conditioner is shut off, wait a minimum
of three minutes before restarting.
The heat from this unit is designed only as a supple-
menial heat source in addition to regular heating
systems.
Control Functions
1. Air Exchanger: Circulates flesh air and
helps remove stale air when in the down
open position. Maximum air circulation
and cooling occur when in the up closed
position.
2. Master Control: Turns unit on and off,
Selects desired (unction of unit, cooling or
heating (on some models) with continuous
air circulation or air circulation without
cooling or heating.
3. Thermestat I Controls unit thermostat,
which regulates room temperature by auto-
matically turning compressor or heating
elements (on some models) on and off.
Cooling Operation
1. Close Air Exchanger
2. Turn Thermostat to "10".
3. Turn Master Control to HIGH COOL.
4. If room becomes too cool for comfort, turn
Thermostat counterclockwise until compres-
sor turns off (air circulating fan will remain in
operation).
5. When the desired comfort level is reached,
Master Control may be turned to lower setting.
6. To turn unit off, or in event of a power inter-
ruption, turn Master Control to OFF.
Heating Operation -
Heating Models Only
'1. Close Air Exchanger,
'_. Turn Thermostat to "1 ".
3. Turn Master Control to HIGH HEAT.
4.. If room becomes too warm for comfort, turn
Thermostat clockwise until heating elements
turn off (air circulating fan will remain in
operation). The temperature will be automat-
ica]]y maintained. Further adjustment of
Thermostat may be needed to reach desired
comfort ]eve],
5. When the desired comfort ]eve] is reached,
Master Control may be turned to LOW HEAT.
6. To turn unit off, or in event of power
interruption, turn Master Control to OFF,
Air Circulation Without
Cooling or Heating
To circulate and filter air, proceed as follows:
'1. Close Air Exchanger,
'_. Turn Master Control to FAN,
Exhaust Operation
Without Cooling or Heating
To exhaust stale ai_; proceed as follows:
'1, Open Air Exchanger.
2, Turn Master Contro] to FAN.