Installation - HAMPTON BAY Room Air Conditioners Installation & Operation Manual

3. WINDOW INSTALLATION (FLUSH MOUNT)
D Top retainer bar D
Slider
Cabinet
Screws
Bottom tie bar
_1" long
D INSIDE VIEW
#8 screws
Cabinet track
Cabinet side seal Bottom tie bar Window sill
bolt
Outer edge of window sill
Leveling bracket
Installing Cabinet in Window (Flush Mount)
1. Attach cabinet side seals to the existing
holes in the cabinet using the six (6) screws
supplied (fig. 5),
2, Open window and mark the center of win-
dow sill. Carefully place cabinet in window
and align center mark on the bottom tie
bar with the center mark on the window
sill (Fig. 5).
3, Close window until it touches behind top
retainer bar. Do not close window so tightly
that sliders cannot move. (Do not release
your grip on the cabinet until the lower win-
dow sash is in its final position) (Fig. 5).
4, Attach the cabinet to the window sill by
driving two (2) 1" long screws through each
cabinet track into the window sill (Fig. 6).
5, Brackets may be attached to cabinet in either
direction for maximum support, depending
on the depth of the window sill. Place the
leveling bracket with leveling bolt under
cabinet and attach to the cabinet with two
(2) #8 screws. Tighten screws through cabi-
net into the smaller holes in the bracket.
Placement of bracket and screws to slots on
cabinet track will depend on size of the win-
Caution: Do not drill a hole in bottom pan. Unit is designed to operate with approximately 1/2" of water in bottom pan.