Advertisement
i
i
You may have serious
in iury or your property
may be damaged
CAUTION
unless
you follow tbe instruction
below.
• Do not coil or wind the power
cord.
This may cause excessive heat resulting in a fire.
• Caution
for 200 - 240V operation
only
This equipment relies on the protective devices in the building installation for short - circuit
mid over - current protection. Refer to the following table for the suitable number and
location of the protective devices which should be provided in the building installation.
INFORMATIVE
EXAMPLES OF PROTECTIVE
DEVICES IN SINGLE - PHASE
EQUIPMENT
OR SUB - ASSEMBLIES
Case A: Equipment
to be connected
to
POWER SYSTEMS
with earthed neutral
reliably identified, except for Case C
below.
Case B: Equipment to be connected to
any supply, including IT POWER
SYSTEMS and supplies with reversible
plugs, except for Case C below.
Case C: Equipment
to be connected
to 3
wire power systems with earthed
neutral reliably identified.
Protection
against
Earth faults
Overcurrent
Earth faults
Overcurrent
Earth faults
Overcurrent
Minimum
number
of fuses or circuit
breaker poles
1
1
2
1
2
2
Location
Phase conductor
Either of the two
conductors
Bothconductors
Either ofthetwo
condu_ors
Each phase
condu_or
Each phase
condu_or
Verify that the protective
devices
in the building
installation
meets
the conditions
in the table prior to installing
the equipment.
• Remove
the power
cord for complete
isolation!
For complete isolation from the mains, remove the power cord from the monitor or from the
wall socket.
Advertisement
