Advertisement
• Do not apply shock to the monitor.
• Do not use monitor
if glass
is broken
or damaged.
If no picture, glass broken, smoke or something is smelling after applying shock to tile
monitor, turn off the monitor and disconnect the power plug from the mains immediately.
_len, call the service center.
If you continue to operate the monitor with such abnormal conditions, it may cause fire or
you may receive an electric shock.
• Do not disassemble
or modify
the monitor.
'Nlere is high voltage portion inside of tile monitor. Disassembling or modification of tile
monitor may cause fire or electric shock.
• Do not use
the monitor
in wet environment.
If you use the monitor in a wet place such as bath or shower room, it may cause fire or
electric shock. Using the monitor beside a window when snowing or raining or by a seaside
are not recommended.
• Do not damage
or modify
the power
cord.
If you put something heavy on tile power cord or pull, squeeze, heat tile cord, it may be
damaged and it may cause fire or electric shock.
If the power cord is damaged, call service center.
lax
WARNING /
Fire or electric
shock may cause death or serious
injury unless
I
you follow
the instruction.
• The
enclosed
power
cord
must
be used!
Failure
to do so may cause electric
shock hazard or fire bazard.
In USA/Canada,
use a UL LISTED/CSA
LABELLED
or CERTIFIED
power cord set
meeting
the following
specifica/ions
:
Rating:
rain. 125V,
10A, Length:
max. 3.0m,
Type:
SVT or SFI'
Plug type: NEMA
5-15P figm-e, Parallel
blade, Grounding
type
In Europe
or 200V
area, a proper
European
standard
approved
power
cord is to be used
with this monitor.
For a ra/ed current
up to 6 A, a type not lighter
than HO5VV=F
3G 0.75 mm_' or H05VVH2-F
3G 0.75 mm
must be used.
• Use only the correct
voltage
power
outlet with safety ground
connection!
100 - 120 V for USA, Canada, etc.
200- 240 V for Europe, etc.
(This monitor will automatically adjust to the input voltage 100 = 120/200
- 240VJ
• Be careful
of power
cord connection!
Before inserting the plug of tile power cord into a socket of tile correct voltage, check thai the
connection portion of the power cord is clean (with no dust). Then, insert the plug of power
cord into the socket firmly, otherwise it may cause electric shock or fire hazard.
• Do not touch the power
plug when
lightning
is close to you.
You may receive an electric shock.
Advertisement
