Advertisement
Connecting
to Video Equipment
(such
as a Laser Disc
player,
a DVD
player,
a DSS,or
a Video
Camera)
• Read
SAFETY
GUIDELINES
(_V] to _V'H_ ) carefully
to ensure
maximum
safety
before proceeding
to these
steps:
1) Choose
an appropriate
site and install
the product
on a level table where the stand is
secure.
• install the monitor
to have ready access to a power
socket available.
2) Make sure that the video
equipment's
power
switch
is off'.
3) Interconnect
the signal input terminal
on the monitor
rear panel and the video equipment's
signal output terminal
to each other using an commercially
available
video cable.
4) Insert one end of the power
cable included
into the rear-panel
power
cable connector
and
the other end into a power
socket.
5) Turn on the monitor,
then the video equipment's
to make
sure that a display
image
appears
on the monitor
screen.
• For instructions
on turning
on the monitor
and adjusting
its display
images,
see
"Operating
Instructions"
( _]
to _]
).
Speaker
Video
equipment
(such as a video disc player,
a DVD player and a video came O
l+-t.,,l
-
+'_+I
c
_U_e if the video
equ pr]e t has an
S video ipIdt tem]i al
• If video equipment
with an S video output
terminal
is used, cabling
by the S video cable is
recommended
to provide
finer video quality.
(if an S video input terminal
and a video input
terminal
connect to the monitor
at the same time, S video
input would govern.)
• If video equipment
is equipped
with component
video output (Y, PLs,PR or Y, C_s, Cr), please
connect
to the corresponding
color (Y, Pts, PR) input jack on the component
input of the
monitor.
NOTE : Y to Y, Pl+-Cl+ to Pl+, PR-Cr to Pm
Advertisement
