Advertisement
• Make the checks suggested below depending on the symptoms observed. If the
symptoms remain uncorrected, contact your dealer,
WARNING
"Customer
servicing
can be hazardous.
See
Symptom
Point
to check
page
• No picture
with the power-
• Check the way the power cable is connected.
[-'.61
indicating
lamp off.
• Press the power switch.
[-'.71
• The message
"POWER
No sync signal is detected.
SAVE"
is displayed.
• Check the way the signal cable is connected.
_1
• Make sure that the switch of the computer,
_]
• No picture
with
the power
imaging equipment,
etc., is turned on.
• Make sure the computer is not in the power-save
_1
indicating
lamp flickering
in
mode.
_2_1
green.
• Check to see if the input selection matches the
connecfion terminal
_2Jl
• The message
"OUT OF
An input signal is not received normally.
_1
FREQUENCY"
is displayed.
• Check to see if the input signal matches the
monitor specifications.
_1
• Check the way the signal cable is connected.
_2j_
• The power
indicating
lamp
is
• Check the contrast and brightness
settings
_
normally
lit but no picture.
(adjust them for higher contrast and brightness).
• Check the way the signal cable is connected.
_7--]
F1j
• The display
image
appears
• Adjust the dot clock frequency
and phase.
flowing
slantwise.
(Adjust the dot clock frequency
first, the dot clock
_.61
• Text
displayed
across
the
phase next.)
_2_1
screen
appears
vertically
(RGB input)
streaked,
with the characters
in vertical
columns
blurred.
• Text
displayed
across
the
i
• Adjust the dot clock phase for the clearest
[1_1
screen
appears
blurred,
i
A
viewing.
(RGB input)
_-2.61
• A fine
pattern
flickers
when
j
displayed
on the screen,
i_
i
L
The remote
controller
does
not work.
• Check to see if the batteries are loaded in the
remote controller
in opposite
direction.
_8-1
• Check to see if the battedes in the remote
controller
are OK.
I
23
Advertisement
