Advertisement
Connecting
to a PC
• Read SAFETY
GUIDELINES
( _]
to _'h]) carefully
to ensure maximum
safety
before proceeding
to these steps:
1) Make sure that the display signals produced by your PC meet the specifications of this
product.
• For the specifications of this product, see Product Specifications ( _2fflto _2_61 ) .
2Choose an appropriate site and install the product on a level table where the stand is secure.
• Install the monitor to have ready access to a power socket.
3) Make sure that your PC's power switch is off.
4) Interconnect the signal input tmrainal (RGB 1) on the monitor rear panel and the display
signal output terminal of the PC to each other using the signal cable included.
• Optional cables are needed to connect to the RGB2 input and audio input terminals.
• If the signal cable included does not match your PC, consult your dealer after reading the
section "Signal lnput'L _2_]
5) Insert one end of the power cable included into the rear-panel power cable connector and
the other end into a mains.
6) Turn on the monitor, then the PC to make sure that a display image appears on the monitor
screen.
• For instructions on taming on the monitor and adjusting its display images, see
"Operating Instructions" (_'9] to _'_9]).
£
Advertisement
