Advertisement
• To turn on the main unit power supply, main unit the MAIN
POWER
switch (@)
of the main unit to ON and then press the SUB POWER
button or the POWER
button of the remote
controller.
• To turn offthe
main unit power supply, press the SUB POWER
button of the main
unit or the POWER
button of the remote
controller,
then set the MAIN POWER
switch (@) to OFF.
• [:'or normal operations, leave the main power switch (@) set to ON and use the sub power
switch or the Power button of the remote controller to turn the power on and off.
Indicating lamp
Power status
Operating
When the main power switch @ is set to
Off
Off
OFF,
When the main power switch @ is set to
ON and Power button of the remote
Off
Lights red
(standby)
controller or the sub power button on the
control panel located at the front part of
the bottom plate is off.
When the main power switch @ is set to
ON and Power button of the remote
Lights or blinks
On
controller or the sub power button on the
green
control panel located at the front part of
the bottom plate is on.
When the indicating lamp blinks in green or the message
o
"POWER SAVE" or "OUT OF FREQUENCY"
appears on
the screen, there is something unusual about the status
of
II tx._llMNn p ower
switch
reception. See "Symptoms That Seemingly Appear to be
Failures."
_1
%_in
unit
%
oao_t_,ll_
_
TIPS
• Avoid
repeatedly
turning
the monitor
on and off at short time
intervals.
• Failures
might result
fi-om such operation.
• Ttlrn off the main power
switch (@) before
leaving
the monitor
out
of use for an extended
period of time.
• If a power
failure
occt_rs while the main unit is rtmning,
it would
be
powered
on upon recovery
from the failure.
Turn off the unit main
power
switch before leaving
the main unit.
Advertisement
