Vcr Functions - Hitachi 27CX1B Operating Manual

USING THE REMOTE TO CONTROL VCR FUNCTIONS
Operating the precoded function for your VCR
This remote is designed to operate different types of VCR's. You must first program the remote to match the remote system
in your VCR. (Refer to pages 28.)
1. Turn on your VCR.
2. Aim the remote control at the front of your VCR.
3. Press the VCR button to switch to the VCR precoded mode.
4. While holding down the VCR button, enter the 2 digit preset code that matches your VCR as shown on page 28.
The remote will turn off your VCR when the correct 2 digit preset code is entered. When this occurs, the remote
control is programmed for your VCR. If the VCR does not turn off after 5 seconds, try a different 2 digit preset code.
5. The remote will now control your VCR.
NOTES:
1. If your VCR cannot be operated after performing the above procedures, this means that your VCR's codes have
not been precoded into the remote.
2. In the unlikely event that your VCR cannot be operated after performing the above procedures, consult your VCR
operating guide.
3. The remote control will remember the codes you have programmed in until the batteries are removed from the
remote control. After replacing the batteries repeat the entire programming procedure stated above.
4. If your VCR does not have a power function, the remote will issue the CHANNEL UP function.
(_ VCR Bu'n'ON
This allows the remote to control your VCR by setting it to VCR mode.
®
PRECODED VCR BUTTONS
These buttons transmit the chosen precoded VCR codes. For some VCR's, you must press the RECORD button
twice to record a program.
(_) EXCLUSIVE TV BUTTONS
These buttons are for operating the TV.
l NOTE: Refer to the instruction manual of the VCR for operation of the buttons exclusively for the VCR.
25