Related Manuals for Hitachi 27CX28B
Summary of Contents for Hitachi 27CX28B
- Page 1 SOLID STATE COLOR TV OPERATING GUIDE IMPORTANT SAFEGUARDS FIRST TIME USE 10-14 REMOTE CONTROL 15-21 SPECIAL FUNCTIONS r--_ Co_,,-..,. 22-23 USEFUL INFORMATION TQB2AA0272 Printed in Mexico...
-
Page 2: Important Safeguards
RECEIVER • Follow all warnings and instructions marked on the television receiver. Our reputation has been built on the quality, performance, and ease of service of HITACHI television receivers. Safety is also foremost in our minds in the design of these units. - Page 3 IMPORTANT PROTECTION AND LOCATION OF YOUR TELEVISION Do not use the television set near -Never block the bottom ventilation slots Avoid dusty places, since water, example, near accumulated dust inside of the set by placing it on a bed, sofa, bathtub, v_shbowi, kitchen sink,...
- Page 4 Introduction Congratulations on Your New Purchase Your new television features all solid state components. It is designed to give you many years of enjoyment. It was thoroughly tested and adjusted at the factory for best performance. In order for you to take full advantage of your new television, please read and follow the installation and operating instructionscontained in this manual.
-
Page 5: Installation
Installation Television Location This televisionisintendedto be used with an optionalstand or entertainmentcenter.Consultyour dealer for available options. Locate for comfortableviewing. Avoid placingwhere sunlightor otherbrightlight (includingreflections)willfall on the screen. Use of some types of fluorescent lighting may red0ce remote control transmitter range. Adequate ventilationis essentialto preventinternalcomponent failure.Keep away from areas of excessiveheat or moisture. -
Page 6: Antenna/Cable Connections
Installation (cont.) Antenna/Cable Connections Antenna Connection - For proper reception of VHF/UHF channels, an external antenna is required. For best reception an outdoor antenna is recommended. Antenna Mode must be set to TV. (Refer to the Antenna section located in the Set-Up Menu.) Indoor Outdoor... -
Page 7: Optional Equipment Connection And Operation
Optional Equipment Connection and Operation To Audio AMP Connection (Stereo) TERMINALS ON BACK OF TV To Auxiliary Input TO AUDIO ..11.ON O ® O,.,u. "IV SPEAKERS R AUDIO VIDEO • To Audio AMP Connect to an extemal audio amp auxiliary input for monitoring sound through a stereo system. NOTE: 'q'O AUDIO AMP"... -
Page 8: Optional Equipment
Optional Equipment Connection and Operation (cont.) Cable Box Connection CABLE TERMINALS ON BACK OF TV TERMINALS ON BACK OF "IV TO AUDIO e®e INPUT "IV SPEAKERS R AUDIO VIDEO Incoming Cable From Antenna Or Cable "IV System Operation Connect incoming Cable to Cable Box ANT INPUT. Connect a cable from Cable Box ANT OUTPUT to TV ANT INPUT. - Page 9 Location of Television Controls Front Control Panel VOL- VOL+ MENU INPUT Power Button - Press to turn ON or OFF. Vol (Volume) Buttons - Press to adjust Sound Level. Ch (Channel) Bjjttons - Press to select programmed channels. Menu Button - Press to display Main Menu and access On Screen features and Adjustment Menus. Input Button - Pressto select TV or Video Input.
-
Page 10: Remote Control
Sleep Timer, Channel, Video Mode, Channel I.D. and Audio Mode. CURSOR Button Press to adjust Audio menus, Video Precoded VCR Buttons menus, select operating These buttons transmit the chosen features when menus are displayed. precoded VCR codes. HITACHI CLU-351U -10-... - Page 11 Remote Control Quick Reference Functional Key Chart POWER Turns TV On and Off CABLE Turns Cable Box On and Off Turns VCR On and Off INPUT Selects the TV Input Mode MENU "iV Activates and Exits TV Menus Selects Channel Selects codein Video Lock Menu Selects Channel in Channel I.D.
-
Page 12: Quick Reference Functional Key Chart
Remote Control Quick Reference Functional Key Chart OPERATES SLEEP Selects 30, 60 or 90 minutes for Automatic Turn Off also use to turn Sleep Timer off by selecting NO MUTE "W Mutes TV Audio Access and exit Closed Caption LST-CH Selects previously tuned channel Mode Selection Buttons... - Page 13 In the unlikely event that your procedures, consult your cable VCR cannot be operated after box operating guide. HITACHI performingthe above procedures, CLU-351U consult your VCR operating guide. The remote control will remember the codes you have programmed...
- Page 14 Control is not designed to control all features that are available in all models. Code Index For VCRs Emerson 00, 01, 10, 16, 23, 33 37, 40, 43 Funai 09, 22 Hitachi 00, 14, 15 14, 26 Magnavox 09, 12, 28 Mitsubishi 16, 23, 26, 45...
-
Page 15: Special Functions
Special Functions MENU Display and Exit Menus LST-CH Cursor Button • or • LST-CH Highlight Desired - Pressing (_) will switch between the last Feature when two channels selected on the numeric keypad. Menu is Displayed NOTE: When scanning channels with the CHANNELA or •... -
Page 16: Video Adjustments
Repeat steps 4 and 5 for the Video Adjustments remaining Picture Adjustments. MENU Reset Press _ twice to exit menus. Use to reset Color, 13nt, Brightness, Contrast, and Sharpness adjustments back to a factory preset level. MENU Press O. Press CURSOR • or • and • or •... - Page 17 Lock Quick Lock Quick Lock Off Prevents video games and other video sources from being To unlock the Quick Lock feature, repeat steps I through viewed. Channel 3, 4, and video inputs are locked out for 3. Enter the same 3-digit code previously used in step 5 12, 24, or48 hours.
-
Page 18: Timer Features
Timer Features Channel I.D. This feature allows you to enter the call names of up to 30 Sleep Timer stations into memory (using up to 4 characters for each This feature is used for automatic turn off in 30, 60, or 90 station). - Page 19 Repeat steps 5 through 7 for setting OFF (time). Timer Features (cont.) 10. Press CURSOR • to highlight CHANNEL. Special Feature: Automatic turn "OFF" after 90 minutes. The TV has a special feature that will shut itself OFF after 90 minutes when turned ON by the program event unless a function key is pressed during the 90 minutes.
-
Page 20: Clock Set
Set-Up Features Clock Set Clock (when set) will display on screen at initial "Turn On", after a channel change and when pressing the RECALL button. The time must be set first in order to operate the Event Program Timer. NOTE: This feature will be disabled when Auto Power On is activated. -
Page 21: Closed Caption
Set-Up Features (cont.) Channel Memory Press CURSOR • or • and • or • to highlight the Set-Up Icon. This feature allows you to select which channels are MENU placed into Channel Scan Memory. Press O to display the Set-Up Menu. Press Press CURSOR •... -
Page 22: Useful Information
USEFUL INFORMATION Troubleshooting Chart Before you call for service, determine the symptoms and make a few simple checks shown below. ANTENNA LOCATION AND/OR CONNECTION SNOWY PICTURE NOISY SOUND <, ANTENNA DIRECTION AND/OR LOCATION ANTENNA LEAD-IN WIRE MULTIPLE IMAGE NOISY SOUND ELECTRICAL APPLIANCES, LIGHTS, CARS AND TRUCKS DIATHERMY AND OTHER MEDICAL EQUIPMENT... - Page 23 Inc. Hitachi has made every effort to assure you hours of trouble free operation from your unit, however, should your television require service, a network of Hitachi Authorized Service Facilities has been established in all 50 states and Puerto Rico.
- Page 24 HITACHI H462441...