Vcr Functions - Hitachi 27Fx49B Operating Manual

Programmin l the Remote
VCR Functions
This remote is designed to operate different brands of VCRs. You must first program the remote to match the remote
system of your VCR.
Procedure
1. Turn ON yourVCR.
2. Aim the remote control at the front of your VCFI.
3. While holding down the VCR button on the remote, enter the 2-digit preset code that matches your VCR. (See
"Component Codes" on page 17 - page 18.) The remote wilt turn off your VCR when the correct 2 digit preset code
is entered. When this occurs, the remote control is programmed for your VCR. If the VCR does not turn off after 25
seconds, try a different code, if available.
The remote will now control your VCR.
4_
Notes
if your VCR will not operate remotely after performing the above procedures, this means that your VCR's code
has not been coded into the remote Please consult your VCR's operating guide.
The remote control wil! remember the codes you have programmed in until the batteries are removed from the
remote control. After replacing the batteries repeat the programming procedure stated above,
If your VCR does not have a remote power function, the remote will issue the CHANNEL UP function.
The MENU button will act as the VCR MENU button [or HITACHI VCRs.
The INPUT button will act as your VCR +100 button, if required.
Cable/Satellite Box Functions
This remote is designed to operate different brands of cable boxes and Satellite boxes. You must first program the remote
to match the remote system in your cable/satellite box.
Procedure
1. Turn ON your cable/satellite box.
2. Aim the remote control at the front of your cable/satellite box.
3. While holding down the CABLE button on the remote, enter the 2 digit preset code (See "Component Codes" on
page 18 - page 19) that matches your cable/satellite box. The remote wiii turn off your cable/satellite box when the
correct 2 digit code is entered. When this occurs, the remote control is programmed for your cable/satellite box. if
the cable/satelIite box does not turn off after 5 seconds, try another 2 digit preset code, if available.
4. The remote will now control your cable/satellite box
Notes
If your cable/satellite box will not operate remotely after performing the above procedures, this means that
your cable/satellite box code has not been coded into the remote. Please consult your cable/satellite box
operating guide.
The remote control will remember the codes you have programmed in until the batteries are removed from the
remote control. After replacing the batteries, repeat the entire programming procedure stated above,
If your cable/satellite box does not have a remote power function, the remote will issue the CHANNEL UP
function.
CABLE/SATELLITE BOX VOR
_16-