Recall Button - Hitachi 27CX1B Operating Manual

USING THE REMOTE TO CONTROL CABLE BOX FUNCTIONS
Operating the precoded function for your cable box
This remote is designed to operate different types of Cable Boxes. You must first program the remote to match the remote
system in your cable box. (Refer to pages 28.)
1. Turn on your cable box.
2. Aim the remote control at the front of your cable box.
3. Press the cable box button to switch to the cable box precoded mode.
4. While holding down the CABLE button, enter the 2 digit preset code that matches your cable box as shown on page
28. The remote will turn off your cable box when the correct 2 digit preset code is entered. When this occurs, the
remote control is programmed for your cable box. If the cable box does not turn off after 5 seconds, try a different
2 digit preset code.
5. The remote will now control your cable box.
®
®
NOTES:
1. If your cable box cannot be operated after performing the above procedures, this means that your cable box
codes have not been precoded into the remote.
2. In the unlikely event that your cable box cannot be operated after performing the above procedures, consult your
cable box operating guide.
3. The remote control will remember the codes you have programmed in until the batteries are removed from the
remote control. After replacing the batteries repeat the entire programming procedure stated above.
4. If your cable box does not have a power function, the remote will issue the CHANNEL UP function.
5. For CLU-361U remote control only, channel A, _p' will control the cable box channel. The number buttons
will control your television channel although your in Cable mode.
CABLE BUTTON
This button allowsthe remoteto controlyour cable box by setting it to CABLE mode.
PRECODED CABLE BOX BUTTONS
These buttons transmit the chosen precoded CATV codes.
TV/VCR BUTTON
When the remote is in CABLE mode, this is the NB button.
(_ ENTER BUTTON
if yourcable box does not have an enter function, this button willsend the TV enter code.
(_) RECALL BUTTON
If yourcable box does not have a lastchannelfunction, this buttonwillsendthe TV channel recallcode.
(_ EXCLUSIVE TV BUTTONS
These buttons are for operating the TV.
27