GE PGSS5PJXASS Owner's Manual And Installation Instructions page 19

Installation Instructions
[] CONNECTING THE REFRIGERATOR
TO THE HOUSE WATER LINE (cont.)
[] If you ore using copper tubing, place a
compression nut and ferrule (sleeve) onto the
end of the tubing coming from the house cold
water supply.
If you are using the GE SmartConnect"
tubing, the nuts are already assembled to the
tubing.
[] If you are using copper tubing, insert the end
of the tubing into the refrigerator connection,
at the back of the refrigerator, as far as
possible. While holding the tubing, tighten
the fitting.
If you ore using GE SmortConnect
TM
tubing,
insert the molded end of the tubing into the
refrigerator connection, at the back of the
refrigerator, and tighten the compression
nut until it is hand tight. Then tighten one
additional turn with a wrench. Overtightening
may cause leaks.
[] Fasten the tubing into the clamp provided to
hold it in position. You may need to pry open
the clamp.
One of the illustrations below will look like the
connection on your refrigerator.
Icemoker-Reodg models
Tubing
Clamp
1/4"Copper
1/4"
Compression
Nut
Ferrule
(sleeve)
Refrigerator
Connection SmartConnecf"
Tubing
Icemoker-lnstolled Models
Refrigerator
Connection
Ferrule
(sleeve)
1/4"
Compression
SmartConnect"
Tubing
Tubing Clamp
1/4" Tubing
19
[] TURN ON THE WATER SUPPLY
(icemoker end dispenser models)
Turn the water on at the shutoff valve (house
water supply) and check for any leaks.
[] PLUG IN THE REFRIGERATOR
On models with an icemaker, before plugging in
the refrigerator, make sure the icemaker power
switch is set to the 0 (off) position.
See the grounding information attached to the
power cord.
[] PUT THE REFRIGERATOR IN PLACE
Hove the refrigerator to its final location. Hake
suretheback sideoftherefrigerator engages the
anti-tip bracket properly. The anti-tip floor bracket
should line up with the cutout in the back bottom
of the refrigerator, and fit through the cutout when
the refrigerator is pushed into position. (Refer to
page 16, Step 2A for more information.)
[] LEVEL THE REFRIGERATOR
Turn the front roller adjusting
screws clockwise to raise the
refrigerator,counterclockwise
to lower it. Use a B/8" hex
wrench with extension, or an
adjustable wrench,
Roller adjusting screws
To adjust the rollers on 21' Counter Depth models:
Thesemodels also have rear adjustable rollers so you
can align the refrigerator with your kitchen cabinets,
Use a B/8" hex wrench with extensionto turn the
screws for the rear rollers-clockwise to raise the
refrigerator,counterclockwise to lower it.