Reversing The Door Swing - GE Spacemaker DSXH43 Owner's Manual & Installation Instructions

Stacking Instructions-Reversing Door Swing
Thenumbers in the illustration correspond to steps.
5. Using file blade end of a put b, knife covered with
masking tape, careflllly remove file hole plugs located
in the bottom of the d_Ter flont panel.
6. Remove the 4 legs flom the d_yer base.
7. Place the d_Ter on mp of the washeL Slide the dryer
back into the rear brackets (7A) then drop the flont
down over the flont b_vmkets (7B).
®
@
/
2
8. Insert the 2 long screws provided in file kit flnough
the holes in the dryer fiont panel and inst_dl into the
flont mounting b_ckets.
9. Install file hole plugs removed in stop 5.
10. Refer m die washer and d_yer installation insmlcdons
for proper installation and flmcfion.
11. S_we file top panel and b_ackets in file case offlmne
sided)y-side use.
REVERSING THE DRYER
DOOR SWING
1. Open the d_yer dooL Remove the 4 hinge hole plugs or
screws flom the left side of door opening. Place nearby
for fimlre installation. NOTE: Youmay need a plastic knife
to help pull out theplugs. Be careful not to scratch thepaint.
2. Remove the four screws fllat secure file door hinges m
the dIyer flont panel. NOTE:
RemoveI screw from each
of the 2 hinges first. Holdthe door firmly beforeremoving the
last 2 screws.
3. Romm file door 180 ° and reinstall file door hinges m file
d_Ter flont panel with the 4 screws.
4. Install file 4 hinge hole plugs or screws fllat were
removed in stop 1 into the open screw holes on the _ight
side of the door opening.
Remove 4 screws--one from eachhingefirst
20