GE PFSF6PKWABB Owner's Manual And Installation Instructions page 20

Installation instructions
INSTALLING THE REFRIGERATOR
(cont.)
[] CONNECTING THE REFRIGERATOR
TO THE HOUSE WATER LINE (cont.)
[] If you are using copper tubing, insert
the end of the tubing into the refrigerator
connection, at the back of the refrigerator,
as far as possible. While holding the
tubing, tighten the fitting.
If you are using GE SmartConnect TM
tubing, insert the molded end of the
tubing into the refrigerator connection,
at the back of the refrigerator, and tighten
the compression nut until it is hand tight.
Then tighten one additional turn with a
wrench. Overtightening may cause leaks.
[] Fasten the tubing into the clamp provided
to hold it in position. You may need to pry
open the clamp.
Ferrule 1/4"
(sleeve) Compression
Refrigerator
Connection
SmartConnect T_
[] TURN ON THE WATER SUPPLY
Turn the water on at the shutoff valve (house
water supply) and check for any leaks.
[] PLUG IN THE REFRIGERATOR
See the grounding information attached to the
power cord.
[] REMOVE THE FRESH FOOD
DOOR HANDLE
Stainless steel:
O REMOVING
THE DOOR
HANDLE: Loosen
the set screws _
with the 3/32"
Allen wrench e
and remove
the handle.
Plastic handle:
Q REMOVING
THE DOOR
HANDLE: Slide
the handle up
and off of the
mounting
fasteners.
Mounting o
Fasteners
NOTE: If the handle mounting fasteners need to
be tightened or removed, use a Phillips-head
screwdriver.
[]
REMOVE THE FREEZER DOOR
HANDLE
Stainless steel and plastic handles:
O Loosen the set screws located on the underside
of the handle with the 1/8" Allen wrench and
remove the handle.
NOTE: If the handle mounting fasteners need to
be tightened or removed, use a Phillips-head
screwdriver.
20