GE PFSF6PKWABB Owner's Manual And Installation Instructions page 17

Installation instructions
REMOVE THE REFRIGERATOR
DOORS (cont.)
[] Lift the door straight up to remove.
J
J
[] Remove the two hex-head bolts and two Phillips-
head screws from the center hinge. Set the hinge,
bolts and screw aside.
i ...... - ......
REPLACING THE REFRIGERATORDOORS
[] Install the center hinge on each side.
[] Lower the refrigerator door onto the center hinge
pin. Ensure that the plastic hinge pin thimble is
on the center hinge pin or inside door hinge pin
hole located in the bottom of the door.
[] Securely tape the door shut with masking tape
or have a second person support the door.
17
REPLACING THE REFRIGERATOR
DOORS (cont.)
[] Insert the top hinge pin into the hinge hole on
top of the refrigerator door. Make sure the door
is aligned with the cabinet and opposite door.
Attach the hinge to the top of the cabinet. Do
not tighten bolts completely.
i
I
I
i o
[] On left-hand doors, 3ass the wires and water line
through the top hinge pin. Then connect the
water line and two connectors.
[] Attach the ground wire with a Phillips-head
screwdriver at the right and left hinge.
[] Make sure the gasket on the door is flush against
the cabinet and is not folded. Make sure the door
is straight and the gap between the doors is even
across the front. While holding the aligned door
in place, tighten the top hinge bolts.
[] Reconnect the two connectors at each side of the
top cap and reattach the three Phillips-head
screws on top.