Table of Contents
Advertisement
ASSEMBLY
INSTRUCTIONS
To avoid injury, do not connect this miter saw to the
power source until this machine is completely assembled
and adjusted, and you have read and understood this
instruction manual.
INSTALLING THE MITER HANDLE (FIG. A)
1.
Carefully thread the miter handle (1) into the hole (2)
located at the front of the miter table.
2.
Tighten.
3.
Loosen handle 1/4 turn or more to unlock the miter
table from its set position.To lock, tighten the handle.
Fig. A
2
SAW BLADE WRENCH (FIG. B)
1.
Store the blade wrench (1) in the saw housing slot (2),
at the rear of the saw base, to prevent loss.
Fig. B
2
RAISING THE CUTTING HEAD (FIG. C)
1.
Push down slightly on the cutting head handle (1).
2.
Pull out the stop latch knob (2).
3.
Allow the cutting head (3) to raise to the up position.
To avoid injury and damage to the saw, transport or store
the miter saw with the cutting head locked in the down
position. NEVER use the stop latch to hold the cutting
head in a down position for cutting operations.
Fig. C
LOCKING THE CUTTING HEAD (FIG. C)
When transporting or storing the miter saw, the cutting
head should always be locked in the down position.
1.
Push the cutting head (3) down to its lowest position.
2.
Push the stop latch (2) into the locking hole (4).
IMPORTANT: To avoid damage, never carry the miter
saw by the switch handle, the cutting arm, or the miter
table handle. ALWAYS use the hand holds in the base.
INSTALLING THE DUST BAG (FIG. D)
1.
To install the dust bag (1), squeeze the metal collar
wings (2) to enlarge the neck opening.
2.
Place the dust bag opening around the dust exhaust
port (3), and release the metal collar wings.
Fig. D
I
2
3
10
Advertisement
Table of Contents
