Table of Contents
Advertisement
PROHIBITED
ACCESSORIES
Use only accessories
recommended for this miter saw.
Follow instructions that accompany accessories. Use of
improper accessories may cause hazards.
The use of any cutting tool except 10 inch saw blades
which meet the requirements under recommended
accessories is prohibited. Do not use accessories such as
shaper cutters or dado sets. Ferrous metal cutting and the
use of abrasive wheels is prohibited.
Blade wrench (supplied)
Adjustablewrench
Phillipsscrewdriver
Slottedscrewdriver
Combination square
Do not attempt to modify this tool or create accessories
not recommended for use with this tool, Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious injury.
RECOMMENDED
ACCESSORIES
Visit your Sears Hardware Department or see the Power
and Hand Tools Catalog to purchase recommended
accessories for this power tool.
COMBINATION
SQUARE MUST BE TRUE
Draw light
,-,
line on board
along this edge. ,. - -'
of
board 3/4" thick.
edge must be
perfectly straight.
To avoid the risk of personal injury, do not modify this
power tool or use accessories
not recommended
by
Sears.
Read warnings and conditions on your CARBIDE TIPPED
SAW BLADE. Do not operate the saw without the proper
saw blade guard in place. Carbide is a very hard but brittle
material. Care should be taken while mounting, using, and
storing carbide blades to prevent accidental damage. Slight
shocks, such as striking the tip while handling, can seriously
damage the blade. Foreign objects in the workpiece, such
as wire or nails, can also cause tips to crack or break off.
Before using, always visually examine the blade and tips
for bent blade, cracks, breakage, missing or loose tips, or
other damage. Do not use if damage is suspected. Failure
to heed safety instructions and warnings can result in
serious bodily injury.
Should be no gap or overlap
when square is flipped over
in dotted position
SAVE THESE INSTRUCTIONS
6
Advertisement
Table of Contents
