Table of Contents
Advertisement
INSTALUNG THE EXTENSION WINGS (FIG. E)
To avoid personal injury or possible damage, support
long workpieces while cutting by installing the extensl0n
wings to increase the width of the workpiece.
NOTE: The extension wings are provided with an end
stop bracket (1), and may be installed with or without it.
To Install with the end stop:
1.
Place bracket (2) on the ends of the extension
wing (3).
2.
Insert the ends of the extension rod into the holes (4)
at the side of the table.
3.
Align the top bracket ho_e (5) to the table hole (6)
from the underside of the table.
4.
Thread the Phillips head bolt (7) through the hole in
the table top, and through the bracket,
5.
Adjust the length of the rods and tighten the bolt.
6.
Adjust the position of the end stop block (1) by
loosening the wing nut (8) and sliding the end stop to
the desired position. Tighten the wing nut.
To Install without the end stop:
1.
Loosen the wing nut and slide the end stop off the
extension rod before installing as above,
'ig. E
0\
7
3.
Loosen the cover plate screw (2) with a Phillips
screwdriver.
4.
Rotate the cover plate (3) to expose the arbor
screw (4).
5.
Place the blade end wrench over the arbor screw.
Fig. F
1
.
7.
(Figure G) Locate the arbor lock (5) on the motor,
below the miter saw switch handle.
Press the arbor lock, holding it in firmly while turning
the blade wrench clockwise. The arbor lock wilt
engage after turning the wrench. Continue to hold
the arbor lock in to keep it engaged, while turning
the wrench clockwise to loosen the arbor screw.
Fig. G
4
5
3
8
REMOVING
OR INSTALLING
THE BLADE
Use only a 10 inch diameter blade.
To avoid injury from an accidental start, make sure the
switch is in the OFF position and the plug is not connected
to the power source outlet.
REMOVING BLADE (FIG. F, G, H)
1.
Unplug the saw from the outlet.
2.
(Figure F) Allow the miter saw to rise to the upright
position. Raise the lower blade guard (1) to the up
position.
11
•
.
Advertisement
Table of Contents
