Assembly - COMPANION 315.241940 Operator's Manual

d_lb WARNII_I" Do not attempt to modify this tool or
createaccessories not recommended for usewith
this tool. Any such aitaratlon or modifl_,tion is
misuse and could result in a hazardous condition
leading to possibleserious personalinjury.
_k WARNINGs Do not connect to power supply until
assembly is complete. Failureto comply could
result in accidental startingand possible serious
personal injury.
MOUNTING HOLES
See Figure 8.
WARNING: Ahe_ysmake sum your compound
miter saw fs securelymounted to a workbench or an
approved wcrkstand. Failureto do so could result
in an accident resultingin poSSibleseriouspersonal
injury.
Your compound miter saw should be permanentlymount-
ed to a firm supportingsurface such as a workbench.
Four bolt holeshave been provided in the saw base for
this purpose. Each of the four mountingholesshould be
bolted securely using3/8 in. machine bolts, lock washers,
and he)( nuts (not inctuded). Bolts shouldbe of sufficient
length to acconvnodate the saw base, lock washers, hex
nuts, and the thickness of the workbench.
Tightenall four bolts securely.
The hoJepe_ern for mountingto a workbenchis shown in
figure 8. Carefullycheck the workbench after mountingto
make sure that no movement can occur during use. If any
tipping, eliding,or walking is notad, secure the workbench
to the floor before operating.
TRACE HOLES
AT THESE LOCATIONS FOR
HOLE PATTERN
TRACE HOLES
ATTHESE LOCATIONS F OR
HOLE PATTERN
BASE
NmUNTING SURFACE
Fig. 8
14