Table of Contents
Advertisement
BEFORE LEAVING THE SAW
• Never leave tool running unattended. Turn power
OFF. Wait for all moving parts to stop.
• Make workshop child-proof. Lock the shop.
Disconnect master switches. Store tool away from
children and other unqualified users.
MITER CUT (FIG. R)
When a miter cut is required, unlock the miter table by
turning the miter handle (1) counterclockwise.
While holding the handle, press down the spring !ock (2)
to release the table from the positive stops• Rotate the
table to the right or left with the miter handle. When the
table is in the deldltDdI_jlion
as shown on the miter
scale (3), release tile spring lock and tighten the miter
handle.
The table is now locked at the desired angle .
Positive stops are provided at 0, 15, 22.5, 31,6, and 45".
IMPORTANT: ALWAYS TIGHTEN the miter table lock
handle before cutting.
Fig. R
COMPOUND
CUT (FIG.T)
When s compound cut is required,
1.
Loosen the bevel lock handle (1) and position the
cutting head at the desired bevel position. Lock the
bevel lock handle.
2.
Loosen the miter table lock handle (2). Press down
the miter spring lock (3) and position the table at the
desired angle. Release the spdng lock and lock the
miter handle.
Fig, T
3
1
BEVEL CUT (FIG. S)
When a bevel cut is required, loosen the bevel lock
handle (1).
Tilt the cutting head to the desired angle as shown on the
bevel scale (2). The blade can be positioned at any
angle, from a 90 +straight cut (0" on the scale) to a 45"
left bevel. Tighten the lock handle (1) to lock the cutting
head in position. Positive stops are provided at 0 and 45 °.
Fig. S
CUTTING BOWED MATERIAL (FIG. U)
A bowed workpiece must be positioned and cut as
illustrated. Do not position workpiece incorrectly or try to
cut the workpiece without the support of the fencs. This
will cause the blade to bind and could result in personal
injury.
Fig. U
Advertisement
Table of Contents
