Installing A Hard Disk Drive - TYAN Transport GS14 (B5121G14S2 Manual

Installing a Hard Disk Drive

NOTE: Make sure that the jumper setting of the hard disk drive is set to "Master." (See the
hard disk drive's documentation for information.)
Please attach the hard bracket to the chassis to prevent enlarging the screw
WARNING:
holes even if you will not use hard disk drive
It is advised that you select a hard disk drive that meets the following specifications. A
hard disk drive that does not meet these specifications can cause reliability problems in
your system.
Peak current draw: must not exceed 1.8 amperes maximum (at 5 volts) and 0.7
amperes maximum (at 12 volts)
Rotational speed: 5400/7200 rpm
Interface: Serial ATA
Operating temperature: must be able to operate in environments up to 55 °C
Operating humidity: 10 % to 90 % (non-condensing)
IDE and SATA hard disk drives cannot be used in combination for RAID function
1. Remove the cabinet cover (see previous section).
19
http://www.TYAN.com