GE AJCH Series Owner's Manual page 9

Installing a J-Model in an Existing Wall Case
IMPORTANT!
GE strongly recommends the removal of the
old waft case and the installation of a new
GE Waft Case. ff you decide to keep the exist-
ing wall case, you may need a kit to ensure
proper performance, ff you DO NOT use a kit,
you run the risk of poor performance or
product failure. This is not covered under
the terms of the GE warranty. _ 4
J-model air conditioners may fit in existing wall
cases. However, they often need a kit to properly
adapt tl_e case to tt_e GE air conditioner. Answer
these questions and see the chart below for the
proper kit.
1 What brand air conditioner will you he replacing?
2 What are the dimensions of the wall case
currently in use ?
What is the model number of the chassis currently
in use ? What is the model (or Type) number of the
wall case currently in use ?
Frequendy, d_eJ-model adapter kit will apply to
anodmr brand model "series" or specific vin-
tage. In tt_ese cases, you need tt_e chassis model
number and/or the wall case or "type" number
to confirm the use of the correct adapter kit.
What type of outdoor grille is used with the cur-
rent wall case?
There may be an architectural grille attached
to a wall case to enhance the exterior appear-
ance of the building. Custom grilles may be
used with J-model wall cases provided a J-model
adapter kit is also used to ensure proper
airflow.
Use GE
Kit Number: For: Description:
RAK56A100
GE RAB13, 14 & 15 Fits all GE wall cases 26"W x 18"H x 24"D
(ACLB & RCL Chassis)
RAR107
Ho_point ACXBI 0 & 11 Adapts an older Hotpoint wall (:ase to a ".]" model (hassis.
(ACTB Chassis) Fits Hotpoint wall cases 25g,"W x 16V, JH x 18%"D
RAR108
Whirlpool Type 23W Adapts WhMpool wall case to a ".]" model ( hassis.
Wall Case Fits WhMpool wall cases 2,57/,,"W x 16_/:"H x 23Ys"D
RAR110 GE P._4B30 Adapts (;E wall case to a "J" model chassis.
("F" models) Fits the RAB 30 wall case 26"W x 18"H x 24"D
RAK123 Fedders Wall Case "A" Adapts Fedders wall case to a "J" model chassis.
Fits Fedders wall (ases 27"W x 16:_Z"Hx 16:_A"D
RAR126 Westinghouse Wall Case Adapts Westinghouse wall case to a ".]" model chassis.
(Type 2626D73H01 ) Fits Westinghouse wall (ases 257,,"W x 157_;"H x 16"D
RAB4{I, 4 7 & 48 Use these kits for all Standard wall case for ".]" model chassis.
other brands not listed. RA(; 13 stamped aluminum exterior grille in( luded.
Remove the existing case and replace.
RAR_0
IL_B36, 37, 38, 46, 47 or 48 If you attach a custom architectural outdoor grille,
@Chassis) use this kit to ensure proper airflow.
RAGI4E P,_4B36, 37, 38, 46, 47 or 48 Archite_ rural louvered exterior grille
(]-Chassis)