IMPORTANT SAFETY INFORMATION. READALLINSTRUCTIONS BEFORE USING. WARNING'! For your safe_ the information in this manual must be followed to minimize the risk of fire, electric shock or personal injury. SAFETY P RECAUTIONS Use this appliance only %r its intended _{:_ T urn the mode...
Page 3
WARNING! USEOFEXTENSION CORDS--115-Volt modelsonly CAUTION: Because of potential safety hazards under certain conditions, we strongly recommend DO NOT use an extension cord with any of the against the use of an extension cord. 230/208 volt models. Howe_; ifvo/l Ill/lSt all extension...
Low -• LOW ......Tim_ / • OFF off/TIMER TEMP Air ConditionerControls Lights beside tbe toucbpadsonthe airconditioner controlpanelindicate the selectedsettings. RemoteControl Whenthe air conditioner i s turnedon,it will Controls automatically startin thesettinglast used. To cancel (CI,) tile On Timer press tile ON/ITOPo ONpad again.
Tile compressor will e_cle on and off a fansetting,wait atleast3 minutes beforeswitchingback to kee I) tile room at tile set level of (omfi)rt. Set tile toa COOL s etting. thermostat at a lower number and file indoor _firwill Fan Switch...
Page 6
About the controlson the air conditionermmodels with touchpads. Auxiliary Controls- TemperatureLimiting To reach auxiliary controls remove fl'ont g_ille. Access them through small rectangular opening above control panel. Temperature limiting can reduce energy costs b)' limiting lowest temperattu'e that can be set fin" cooling,...
NOTE: If youmovetheswitchfroma coolor heat Heat Pump Models settingto OFF or to a fansetting,wait at least 3 minutes beforeswitchingbacktoa coolor heat When outdoor temperature is lower setting. A 3-minute delay is automat/cally provided than 25°F.,...
Fan Switch To reach tile tim switch (es) remove tile fl'ont grille. On Hea_/Cool and Heat Pump models, tile tim switch levex_ are located in holes accessed through tile control box. Tile top switch is fin _COOL settings and tile bottom sMtch is fin"...
Toremove: 1. Pull the filter out. 2. Remove the two grille scre_vs. On somemodels Toreplace: Hook the tabs on the ti'ont grille even with the tabs on the case and snap into place. Replace the scre_vs and filte_: On somemodels...
Tomaintain optimum performance, clean the filter at least every30 days. Air Filter To remove the a# filter, on uther models: Pull it down. Dir:y filte_Needs cleaning Clogged filter Greatly reduces cooling, heating and airflow. Turn the a# conditioner off before cleaning.
Case. If you decide to keep the existing wall case, basic mechanical skills. you may need a kit to ensure proper performance. If you DO NOT use a kit, you run the risk of poor • Completion time - Approximately 1 hour performance or product failure.
RAK1102 GE RAB30 Adapts GEwall case to a "J" model chassis. ("F" models) Fits the RAB 30 wall case 26"W x 18"H x 24"D RAK123A64 FeddersWall Case "A" Adapts Fedderswall case to a "J" model chassis. Fits Fedderswall cases 27"W x 16sA"Hx 16sA"D...
Remove shipping pads (if present) [] CAREFULLY SLIDE AIR CONDITIONER BACK INTO CASE Make sure that the tubing on the unit does not touch the wall case and that the case installation is secure.
Page 15
Do not allow the wall case to be used in lieu of a lintel. Flashing - Install flashing (drip rail) as shown to prevent water from dripping...
Page 16
• The air conditioner can be installed without 31" to 43" (With filler panels) accordion panels if needed to fit in a narrow window. See the window opening dimensions to the right. • All supporting parts must be secured to firm wood, 261/4"...
Page 17
While holding the grille at a 45 ° angle, insert it into the clips at the top of Remove and discard the shipping screw the case and push the bottom in.
Page 18
Do not fully outside. Line up the "V" notch with 12%" marks. tighten the spacer mounting screws at this Drill pilot holes and attach the sill supports. time. Average sill Type Type E Spacer Spacer mounting screws Type (A)
Page 19
3" from the top and the bottom. Squeeze Mark the A and B measurements on each and push the clips to fit in the window track and side of the filler panel board. Cut the panels the tab into the sill support.
Page 20
Place the vinyl window gasket over the case top Case holes gasket. Insert the panel tabs through the slits in the gasket. Cut the gasket on each side to the width of the window. NOTES: • The case should have a 1/8" minimum...
Page 21
Carefully slide the air conditioner back into the case. plate Locking _ •s hten Reattach the front grille. An opening for the power cord is on the bottom of the front grille. Fill holes and cracks with caulking provided the installer.
Before youcall for service... Troubleshooting -tips: Save time and money! Review the chart below first and you may not need to call for service. Possible Causes What ToDo Airconditioner The air conditioner • Make sure tile air conditioner plug is pushed does notstart is unplugged.
This warranty is extended to the original purchaser and any succeeding owner for products purchased for home use within the USA and Canada. If the product is located in an area where service by a GE Authorized Servicer is not available, you may be responsible for a trip charge or you may be required to bring the product to an Authorized GE Service location for service.
ScheduleService go. corn Expe_qt (;E repair service is onl_ one step awa_ fl'om }ore" door: Get on-line and schedule _our servire at }our convenience 24 hours an} da} of tile }ear! (-)r call 800.GE.CAI_ES (800.432.2737)
Need help?
Do you have a question about the AJHS10DCC and is the answer not in the manual?
Questions and answers