[-4] REVERSING THE HARDWARE (CONT.I
hinge and screws at top right with screws at
top left of cabinet.
Do not tighten screws on hinge side
at this time.
Installingthe hingeon the left. Installingthe hinge on the right.
• Some hinges have %ur holes. Which holes you use
for installing the hinge depends
on which side you
install the hinge.
The outer edge of the hinge should be parallel to the
edge of the case for correct installation.
Remove plug button from the top hinge hole on the left
side of the door and insert it into the hole on the
opposite side that was vacated by removal of the top
5.1.4 Pull the plug button from the front of the door and
transfer it to the opposite side.
handle on the
THE DOOR HANDLES
plug using a tape-tipped
putD _knife under
the edge, and remove the screw
the two screws holding
to the top of the door.
iXfove the plastic door stop and screws from
the right side to the left side.
Move the metal door stop from the right side
to the ld't side and trans[cr
the scrc_x to the
side of the doon
to the right side of the
door with screws at the top
and under the handle