Jeep Compass Owner's Manual page 32

30 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
NOTE:
If you do not hear the chime it means that the system
did not enter the programming mode and you will
need to repeat the procedure.
Use the Automatic Unlock Doors On Exit feature in
accordance with local laws.
Automatic Unlock Doors on Exit Programming
The Automatic Unlock Doors On Exit feature can be
enabled or disabled as follows:
For vehicles equipped with the EVIC, refer to "Per-
sonal Settings (Customer-Programmable Features)"
under "Electronic Vehicle Information Center (EVIC) –
If Equipped" in Section 4.
For vehicles not equipped with the EVIC, perform the
following procedure:
1. Close all doors and place the key in the ignition.
2. Within 15 seconds, cycle the ignition switch between
LOCK and ON and then back to LOCK four times ending
up in the LOCK position (do not start the engine).
3. Within 30 seconds, depress the power door UNLOCK
switch to unlock the doors.
4. A single chime will indicate the completion of the
programming.
5. Repeat these steps if you want to return this feature to
its previous setting.
NOTE:
If you do not hear the chime it means that the system
did not enter the programming mode and you will
need to repeat the procedure.
Use the Automatic Unlock Doors On Exit feature in
accordance with local laws.