Operating Instructions - Radio Mode - Jeep Compass Owner's Manual

Operating Instructions — Radio Mode
NOTE: The ignition switch must be in the ON or ACC
position to operate the radio.
Power Switch/Volume Control (Rotary)
Push the ON/VOLUME control knob to turn on the
radio. Push the ON/VOLUME control knob a second
time to turn off the radio.
Electronic Volume Control
The electronic volume control turns continuously (360
degrees) in either direction without stopping. Turning the
ON/VOLUME control knob to the right increases the
volume and to the left decreases it.
When the audio system is turned on, the sound will be
set at the same volume level as last played.
UNDERSTANDING YOUR INSTRUMENT PANEL 213
SEEK Buttons
Press and release the SEEK buttons to search for the next
listenable station in AM/FM mode. Press the right switch
to seek up and the left switch to seek down. The radio
will remain tuned to the new station until you make
another selection. Holding either button will bypass
stations without stopping until you release it.
Voice Recognition System (Radio) — If Equipped
Refer to "Voice Recognition System (VR)" in Section 3.
Voice Recognition Button (UConnect Hands-Free
Phone) — If Equipped
Press this button to operate the Hands-Free Phone
(UConnect ) feature (if equipped). Refer to "Hands-Free
Communication (UConnect )" in Section 3.
If your vehicle is not equipped with or this feature is not
available on your vehicle, a "Not Equipped With
UConnect" message will display on the radio screen.
4