Optional Front Trim Installation; Install Filters; Check Operation; Range Hood Use - KitchenAid KHTU705RSS0 Installation & Use Manual

Optional Interchangeable Front Trim Installation
This hood comes standard with an Architect
steel front trim piece. To replace the standard front trim piece with
an optional purchased front trim piece:
1. Reach inside the front of the hood and locate a hex nut
approximately 3" (7.6 cm) in from both outside edges.
2. Remove the 7 mm hex nuts.
A
B
3. Pull the trim piece straight out.
4. Insert the studs on the back of the new trim piece through the
holes in the front of the hood.
5. Replace the hex nuts and tighten securely.
Removable Interchangeable Front Trim Part Numbers:
30" (76.2 cm) models
Color Series
White Architect
Black Architect
Biscuit Architect
Stainless Pro Line
Meteorite Pro Line
36" (91.4 cm) models
Color Series
White Architect
Black Architect
Biscuit Architect
Stainless Pro Line
Meteorite Pro Line

Install Filters

1. For recirculating installations only, install the charcoal filters
included in Recirculation Kit Part Number 4396565. Place the
charcoal filter against the blower cover and rotate to the right
(clockwise) to attach to cover. Repeat with other charcoal filter.
A
® series stainless
C
A. Hood
B. Hex nut
C. Trim piece
Part Number
® 8212462
® 8212463
® 8212461
® 8212464
® 8212465
Part Number
® 8212467
® 8212468
® 8212466
8212469
®
® 8212470
A. Filter
2. Replace metal filter. Place back edge of metal filter into
channel at rear of hood. Push filter up while pushing tab back.
When filter is in place, release tab. Locking pin will hold filter
in place.

Check Operation

1. Check operation of the range hood by turning on the power.
2. The range hood controls are located in front on the underside
of the range hood.
A
3. Move the light switch to "1" position. The light should turn on.
4. Move blower switch to "1" position. The blower should
operate.
5. Move the blower speed switch to "1" position for low speed,
"2" position for medium speed or "3" position for high speed.
6. Move blower and light switches to "0" position to turn blower
and light off.
7. If the range hood does not operate, check to see whether a
circuit breaker has tripped or a house fuse has blown.
Disconnect power supply and check that the wiring is correct.
NOTE: To get the most efficient use from your new range hood,
read the "Range Hood Use" section.

Range Hood Use

The range hood is designed to remove smoke, cooking vapors
and odors from the cooktop area. For best results, start the hood
before cooking and allow it to operate several minutes after the
cooking is complete to clear all smoke and odors from the
kitchen.
The hood controls are located in front on the underside of the
range hood.
A
C
B
A. Controls
B. Light switch
B
A. Controls
B. Filters
D
C. Blower switch
D. Blower speed switch
9