Table of Contents
Advertisement
Message
Card has no data.
Card is not formatted.
Format the card now?
Control Information
Error.
DISC ACCESS
DISC ALMOST FULL
Disc error has occurred.
Finalising is not
complete.
Disc error has occurred.
Format the disc now?
Disc error has occurred.
Formatting is not
complete.
Disc error has occurred.
Keep disc inside &
restart.
Disc error.
Cause & Troubleshooting
This message will appear when the
card inserted on which no still is recorded. (It will appear if you
attempt playback or editing on Disc Navigation, but will not appear
if you press
on camera through image.)
Was the card formatted on PC? When using the card on this DVD
video camera/recorder, choose "YES" and format it.
Mismatch may occur between the recorded image and scene
information.
Update the control information.
•
Use another disc.
•
See *3 on page 153.
The recorded scene is being stored on disc.
Wait until the message disappears, and you can start to use the
DVD video camera/recorder.
This DVD video camera/recorder is verifying whether the correct
disc has been inserted.
Wait until the message disappears, and you can start to use the
DVD video camera/recorder.
This message will be displayed for a little longer when the date
changes.
The disc will soon be full, and recording will be impossible.
Delete unnecessary scenes and try the disc again, or use another
disc.
•
Disc error occurred during finalising, and finalising failed.
Replace the disc.
•
See *3 on 153
•
Has the disc been initialised on PC? Has initialising the disc on
PC been interrupted?
Choose "YES" and initialise the disc when using it on this DVD
video camera/recorder. initialising the disc will erase all data on it.
•
See *2 on page 153.
The disc may be dirty.
Remove the disc and wipe off fingerprints, dust, etc. before reusing
it, or use another disc.
This message may also appear if you insert a disc for which
formatting was interrupted midway. In this case, use another disc.
Disc error could have occurred during editing of scenes.
Turn off the DVD video camera/recorder with the disc being used in
it, connect AC adapter/charger, and then power the DVD video
camera/recorder again. Repair of scenes will be tried.
•
Use another disc.
•
See *3 on page 153.
•
Mismatch in recording information may be caused by editing
done on some device other than this DVD video camera/recorder.
initialise the disc or use another disc.
•
initialising the disc will erase all data on it.
button is pressed with a
Reference
page
125
126
23, 75
51, 54
27, 28, 99
127
125
75, 125
41
23, 75
125
149
Advertisement
Table of Contents
