Recording Movie - Hitachi DZMV350EUK Instruction Manual

Recording Movie

Insert a recordable DVD-RAM or DVD-R disc into this DVD video camera/recorder.
ACCESS/PC
indicator
Pressing REC
once will start
recording;
pressing it
once again will
temporarily
stop recording.
1
Turn the DVD camera/recorder on.
Set the power switch to " VIDEO" to turn the
DVD video camera/recorder on.
After the ACCESS/PC indicator goes out,
perform the subsequent operation:
2
Check the subject on the screen (viewfinder or
LCD).
If using the viewfinder, pull it out.
3
Press the REC button.
The "/" mark in the viewfinder or on the LCD
screen will change to the "0" mark, and
recording will start.
During recording, the recording indicator on the
front of DVD video camera/recorder will light.
Pressing REC again during recording will set the
DVD video camera/recorder to the recording
pause status.
4
When recording is finished, turn the DVD video
camera/recorder off.
Power switch
:
Note
•
See page 145 when recording movie is not possible.
•
See page 145 if it takes some time before recording is
possible.
•
See page 63 for on-screen information display.
•
It is recommended that you use DVD-RAM disc from
which recorded contents can be deleted.
•
Sound is recorded from the stereo microphone on the
front of DVD video camera/recorder: Take care that this
microphone is not blocked.
•
You can press the REC button immediately after the DVD
video camera/recorder enters the recording pause
status, but no further recording can be made while "DISC
ACCESS" is being displayed. Recording will restart after
the message disappear.
•
Take care that power is not interrupted while the
ACCESS/PC indicator is blinking.
•
The minimum recordable time of movie is approximately
3 seconds.
•
See page 91 for setting of Record LED (recording
indicator) On/Off.
•
For various functions available during recording, see
"Setting Up Camera Functions" on page 79.
•
Hitachi cannot be responsible for video and audio that
cannot be recorded or edited because of any defect.
•
The power switch can be changed over even during
recording, but the operation will not be changed.
•
Each time the DVD video camera/recorder enters the
recording pause status, the counter display will be reset
to "0:00:00".
•
When using DVD-R disc, do not perform the following, or
data on the disc may not be read:
- Using another device, doing additional recording on
DVD-R disc recorded on this DVD video camera/
recorder
- Using this DVD video camera/recorder, doing
additional recording on DVD-R disc recorded on
another device
51