Drive Clutch Lever (Sd, S3D); Shift Lever (S3D); Cutting Height Adjustment Levers - Honda HRT216SDA Harmony II Owner's Manual

CONTROLS

Drive Clutch Lever (SD, S3D)

The drive clutch lever engages
(push forward) and disengages
(release) the transmission that
drives the rear wheels. The drive
clutch lever should only be
engaged after the engine has
been started.

Shift Lever (S3D)

The shift lever is used to select the
ground speed. 1 is the slowest,
and 3 is the fastest setting. The
shift lever may be used any time a
change in ground speed is
required.

Cutting Height Adjustment Levers

There are six approximate settings [3/4 ~ 3-1/4 in. (19 ~ 79 mm)]. The
adjusters move back to lower and forward to raise the mower deck.
For the best overall lawn finish, each wheel should be adjusted to the
same position.
10
SHIFT LEVER (S3D)
3/4" (19 mm)
1-1/4 " (29 mm)
1-3/4" (41.5 mm)
2-1/4" (54 mm)
2-3/4" (67 mm)
3-1/4 (79 mm)
REAR ADJUSTMENT LEVER
RIGHT SIDE SHOWN
DRIVE CLUTCH LEVER (SD, S3D)
FRONT
ADJUSTMENT
LEVER