Alarm Feature "C" Programming - Autopage C3-RS1100 OLED Installation Manual

(The system Can not
be Arm with the
engine running)
Enable the out of
7 +
range check
Exit: Turn Ignition to 'ON' position, or leave it for 15 seconds. 3 long chirps & 3 parking
light flashes will confirm exit.
Comfort Feature:
Some Vehicles have a special "COMFORT feature". When you lock the door with the
key, you can keep turning the key in the door for about 5 to 7 seconds and the window
will close directly. If your vehicle has the "COMFORT feature" and you wish for the door
to be locked and the window to be closed automatically at the same time by remote
control, you can set the alarm feature " B-3 "with comfort feature".
ALARM FEATURE "C" PRORAMMING:
1 Turn the Ignition 'switch 'ON/OFF' 3 TIMES and stay i n OFF position.
2 Push the Valet switch 7 times (holding in on the 7th push) until three chirps with
one long chirp is heard then release the valet switch. You are now in the Alarm
feature "C" programming mode.
3 Press and release the transmitter button corresponding to the feature you want to
program.
One Chirp / LED
Press
one pulse
Transmitter
Factory Default
Button
Setting
1
H6/3 Pink Wire =
Two step door
unlock output
C3 RS1100REV. A
The shock sensor The shock sensor
will be by-pass three
by-passed upon minutes after
engine running. armed.
(The engine will (The engine will
run by itself after run by itself after
the ignition is the ignition is
turned off) turned off)
Five chirps = Press and
to control Engine run time for three minutes and the shock
sensor will be by-pass upon engine running.
Six chirps = Press and buttons at the same time
to control Engine run time for five minutes and the shock
sensor will be by-passed upon engine running.
Disable the out of
range check.
Two Chirps / LED Three Chirps /
two pulses LED three pulses
H6/3 Pink Wire =
H6/3 Pink Wire =
Start Status
Factory Security
Output
Disarm Signal
(Shock Sensor
Output
Bypass)
21
Press and
buttons at
the same time
to control
Engine run time
for one minute
and the shock
sensor will be
by-passed upon
engine running.
buttons at the same time
Four Chirps / LED
four pulses
H6/3 Pink Wire =
Start Status Output
(Shock Sensor
Bypass 20 SEC)