Advertisement
Available languages
Available languages
INSTALLING
BITS
See Figure 7.
•
Lock the switch trigger by placing the direction of
rotation selector in center position. See Figure 13.
•
Open or close chuck jaws to a point where the open-
ing is slightly larger than the bit size you intend to use.
Also, raise the front of your drill slightly to keep the bit
from falling out of the chuck jaws.
•
Insert drill bit straight into chuck the full length of the
jaws as shown in Figure 7.
CHUCKJAWS
UNLOCK
DRILLBIT
LOCK
(Tighten) CHUCKSLEEVE
RIGHT
Fig. 7
•
Tighten the chuck jaws on drill bit. To tighten, grasp
and hold the drill with one hand, while rotating the
chuck sleeve with your other hand.
Note: Rotate the chuck sleeve in the direction of the
arrow marked LOCK to tighten chuck jaws.
•
Do not use a wrench to tighten or loosen the chuck
jaws.
_1, WARNING:
Make sure to insert drill bit straight into
chuck jaws. Do not insert drill bit into chuck jaws at
an angle and then tighten, as shown in Figure 8. This
could cause drill bit to be thrown from drill, resulting in
possible serious personal injury or damage to the
chuck.
REMOVING BITS
See Figure7.
•
Lock the switch trigger by placing the direction of
rotation selector in center position. See
Figure
f3.
•
Loosen the chuck jaws from drill bit.
•
To loosen, grasp and hold the drill with one hand,
while rotating chuck sleeve with your other hand.
Note: Rotate chuck sleeve in the direction of the arrow
marked UNLOCK to loosen the chuck jaws.
•
Do not use a wrench to tighten or loosen the chuck
jaws.
•
Remove drill bit from chuck jaws.
USING
DEPTH
GAGE
ROD
See Figure 9.
A depth gage rod has been packed with your hammer drill
to assist you in controlling the depth of drilled holes.
•
Loosen wing screw on auxiliary handle.
•
Orient depth gage rod so that markings on depth gage
rod face markings on wear plate. See Figure 9. Insert
depth gage rod through hole on auxiliary handle.
•
Adjust depth gage rod so that the drill bit extends
beyond the end of the red to the required drilling
depth.
•
Tighten wing screw securely. This secures depth
gage rod at desired depth of cut. It also secures
auxiliary handle.
WING
SCREW
WEAR
PLATE
DRILLBIT
DRILLING
DEPTH
tILLING
TO
DEPTH
DEPTH
AUXILIARY
HANDLE
MARKINGS ON
DEPTHGAGEROD
Fig. 9
Fig. 8
When drilling holes with the depth gage rod installed, the
desired hole depth has been reached when the end of the
rod comes in contact with the surface of the material
being drilled.
11
Advertisement
