Craftsman 315.269290 Operator's Manual page 7

HAMMER DRILL
Chuck
Motor
Gear Train
Switch
No Load Speed
Hammer Speed
Clutch
Maximum Torque
CHARGER
Rating
Charging Voltage
Charge Rate
BATrERY PACK
315.269280
1/2 in. Keyless
DC Motor 18 Volt
Two Speed
Variable Speed
0-400 RPM (Low)
0-1400 RPM (High)
0-6,400 BPM (Low)
0-22,400 BPM (High)
24 Positions
450 in./Ibs
Item No. _911040
(981399-001)
120 V, 60 Hz, AC only
9.6 - 24 Volt
1 Hour
Item No. 9_11034
(981404-001)
315.269290
1/2 in. Keyless
DC Motor 24 Volt
Two Speed
Variable Speed
0-400 RPM (Low)
0-1400 RPM (High)
0-6,400 BPM (Low)
0-22,400 BPM (High)
24 Positions
640 in./Ibs
Item No, -9 11040
(981399-001 )
120 V, 60 Hz, AC only
9.6 - 24 Volt
1 Hour
Item No. -9 11035
(981405-001)
KNOW YOUR HAMMER DRILL
See Figure 1.
Before attempting to use your hammer drill, familiarize
yourself with all operating features and safety
requirements.
KEYLESS CHUCK
Your hammer drill has a keyless chuck that allows you to
hand tighten or release drillbit in the chuck jaws.
SWITCH
To turn your hammer dri{I ON, depress the switch trigger.
Release switch trigger to turn your hammer drill OFF.
SWITCH LOCK
The switch trigger can be locked in the OFF position. This
feature helps reduce the possibility of accidental starting
when not in use.
VARIABLE SPEED
This tool has a variable speed switch that delivers higher
speed with increased trigger pressure. Speed is
controlled by the amount of switch trigger depression.
TWO SPEED GEAR TRAIN
Your hammer drill has a two speed gear train designed
for drilling or driving at HI or LO speeds. A slide switch is
located on top of your drill to select either HI or LO speed.
7
FORWARD/REVERSE SELECTOR
(DIRECTION OF ROTATION SELECTOR)
Your hammer drill has a forward/reverse selector located
above the switch trigger.
WRIST STRAP
A wrist strap is provided to reduce the chances of dropping
your hammer drill. Place one hand through the wrist strap
when carrying tool.
BIT STORAGE
When not in use, bits provided with your hammer drill can
be placed in the storage area located on the bottom of the
motor housing.
LEVEL
To keep drill bit level during drilling operations, a level is
located on the back of the motor housing.
AUXILIARY HANDLE
An auxiliary handle is packed with your hammer drill for
ease of operation and to help prevent loss of control.
DEPTH GAGE ROD
A depth gage rod has been packed with your hammer drill
to assist you in controlling the depth of drilled holes.
,_ WARNING: If any parts are missing, do not operate
your hammer drilluntil the missing parts are replaced.
Failure to do so could result in possible serious
personal injury.