Remote Control Features - GE AE1CDIOAM Owner's Manual And Installation Instructions

About the remote control.
Theremote control transmits the signals to the
system.
Featuresand appearance may vary.
AUTO--In this mode, the unit automatica%
controls the room temperature within the
range of 77°F and 68°F. The fan will run
continuously while the unit is in AUTO mode.
When the room temperature exceeds 77°F, the
unit will go into COOLMode. When the room
temperature drops to 73°F, the fan will
continue to run but COOLMode will turn off.
When the temperature drops below 68°F, the
unit will go into HEAT Mode. When the
temperature reaches 73°F, the fan will
continue to run but HEAT Mode turns off.
NOTE:This temperature range setting cannot
be adjusted and will not be displaged.
¢_ COOL--Use to cool the room to the desired
temperature set between 61°F and 86°F.
NOTE:The unit will not provide optimum
cooling if the outside temperature is below
60°F. Under certain conditions, the unit mag
activate the antifreeze protection cgcle for
approximatelg 5 minutes to remove ice from
the indoor coil.
666DRY--Use to dehumidifg the room. The fan will
run at a fixed low speed to provide maximum
dehumidification. The temperature can be set
between 61°F and 86°F.
_€ FAN--Use to turn ON and OFFthe fan-onlg
operation. COOL, HEATor DRYmode will not
be provided.
_X HEAT (on models so equipped)--Use to warm
the room to the desired temperature set
between 61°F and 86°F.
NOTE:The unit will not provide optimum
heating if the outside temperature is below
14°F. Under certain conditions, the unit mag
activate the antifreeze protection cgcle for
approximatelg 8 minutes to remove ice from
the outdoor coil. During this cgcle, it is normal
to hear operating sounds such as refrigerant
flowing inside the sgstem.
e
o
o
______@
@
-- Operation
-- Sleep on
gon
-- Clock and timer