Power Line - GE AE1CDIOAM Owner's Manual And Installation Instructions

Installation Instructions
INSTALLATION (cont.}
[_]WIRE THE OUTDOOR UNIT
1. Open the cover of the outdoor unit.
2. The connecting wire lead from the terminal board
of the indoor unit must be connected correctly.
3. The connecting wire should be a little longer so
that it can be maintained easily.
6-wayterminal b oard
\
,x
\\
O
©
Wrapelectrical c ordswith attached
metaltie to providestrainrelief.
10,000 and14,000 BTUModels
115VModels Outdoor u nit Indoor unit
Tobranch
circuit
Power supply _]
roun
%1 will be usedfor neutral
in 115V models.
230/208V Models Outdoor u nit
Power supply _
T° r nchl
circuit
Ground_ I
Indoor unit
Fsq WIRE THE OUTDOOR UNIT (cont.}
NOTES:
• Wiring should be consistent with the above wiring
diagrams.
• Wiring must be correct.
• Tighten the nut of the terminal board to keep the
board secured.
• After tightening, the wire cannot be removed if
pulled.
• Incorrect wiring will cause the air conditioner to
work abnormally.
• Incorrect grounding will cause a short circuit.
• Electrical connections must be made by a qualified
electrician.
• All electrical work must be completed according to
local codes and regulations.
[] INSTALL THE POWER LINE
1. Open the wiring cover and remove the knockouts.
2. The connector should be secured by the nut, and
the wiring cover should be replaced and secured
with the included screw.
3. All wiring should be protected by liquid-tight
tubing, and connections to the wiring cover
should be with liquid-tight connectors.
14
Electrical b ox
assembly
Wiringcover
Connector
NOTES:
• The connecting wire and connection tube cannot
touch each other.
• The top cover of the outdoor unit and the electrical
box assembly should be fixed by the screw.
Otherwise, it can cause a fire or a short circuit
caused by water or dust.
• Use a UL-approved electrical branch circuit
disconnect for providing supply voltage to the split
system outdoor unit. Locate the disconnect within
sight and readily accessible per NEC and local
codes.