0_ Electricalwiring; Wiring Indoor Unit - GE AE1CDIOAM Owner's Manual And Installation Instructions

Installation Instructions
INSTALLATION (cont.}
[_] CONNECT ELECTRICAL WIRING
BETWEEN INDOOR AND OUTDOOR
UNITS
• All wiring should be rated appropriately for the
current value listed on the rating plate.
• The power supply should accommodate the rated
voltage.
• Wiring must be done by a qualified electrician
according to local codes, regulations and this
manual.
• All wiring connections should be tightened securely.
[61WIRE THE INDOOR UNIT
NOTE: Use UL-approved electrical branch circuit
disconnect for providing supply voltage to split system
indoor and outdoor units. Locate disconnect within sight
ond readilg occessible per NEC and local codes.
1. Open the front access panel.
2. Remove the cover plate of the electrical box.
\
::::::: ' :_ Access panel
i -- Cover plate
J o
3. On the back of the indoor unit, remove the
conduit connecting cover. Using the fixing nut,
connect the conduit to the connecting cover.
Route the wire leads through the unit to the
electrical box area. Reinstall the connecting cover.
Back of unit IIII
Fixing nut /1/
Connecting cover
Conduit
12
F6]WIRE THE INDOOR UNIT {cont.}
NOTE: Wiring must be done by a qualified electrician
according to the local codes and regulations and
this manual. The connecting wire should be correctly
connected to the circuit interface.
Electrical w iresmustbe secured
with attached strainreliefs.
_w -way
terminal
board
er
j onnection
cord
115VModels Outdoor u nit Indoor unit
Tobranch
circuit
Powersupply _ :tI:i!
roun
3.
o
_3J
B_
%1 will be usedfor neutral
in 115V models.
230/208V Models
Outdoor u nit
Tobranch
circuit
Powersupply _1
Indoor unit
NOTES:
• Wiring should be consistent with the wiring
diagrams above.
• Tighten the nut of the terminal board to keep
the board secured.
• After tightening, the wire cannot be removed
if pulled.
• Incorrect wiring will cause the air conditioner
to work abnormally.
• Incorrect grounding will cause a short circuit.
4. Replace the cover plate over the electrical box
and lower the access panel into position.