Table of Contents
Advertisement
Available languages
Available languages
Installation
Instructions
Read these instructions
completely
and carefully; then follow
step by step.
SELECT THE BEST LOCATION
r_ INDOOR
UNIT
• Do not allow ang heat or steam near the unit.
• Select a location where there are no obstacles
in front of the unit.
• Make sure that condensate
drainage can be
convenientlg
routed awag.
• Do not install near a doorwag.
• Ensure that the space around the left and right
of the unit is more than 6". The unit should be
installed as high on the wall as possible, allowing
a minimum
of 6" from ceiling.
• Use a stud finder to locate studs for mounting
and
to prevent unnecessarg
damage to the wall.
• Install on studs and in a location from which
the condensation
water can be drained out
convenientlg
and that permits easg connection
with the outdoor
unit.
• Do not cover the inlet and outlet so that the
outflow
air can reach all parts of the room.
• Install in a location that is strong enough to
withstand
the full weight and vibration
of the unit.
• Be sure that the installation
conforms to the
installation
dimension diagram.
• Leave enough space to allow access for routine
maintenance.
The height of the installed location
should be 79" or more awag from the floor.
• Install in a location that is 3 ft. or more awag from
other electrical
appliances,
such as televisions and
audio devices.
• Select a location that gives gou easg access to
remove and clean the filter.
Morethan6"
More
f,
_ ,
,
....
More
Morethan79"
[]OUTDOOR
UNIT
• If an awning
is built over the unit to prevent direct
sunlight or rain exposure, make sure that heat
radiation
from the condenser
is not restricted.
• Ensure that the space around the back and sides
is more than 12". The front of the unit should have
more than 79" of space.
H
Morethan12"
Theplatformmust
support a minimumof
Morethan79"
200Ibs.SeeInstallation
Dimensions f ormounting
holespacing.
• Install in a location that is strong enough to permit
safe installation
and to withstand
the full weight
and vibration
of the unit.
• Construct
and anchor o strong and level mounting
base or pod for the outdoor
unit.
• Anchor the outdoor
unit through
its four mounts,
using bolts.
• Select o location from which noise and outflow
air emitted bg the unit will not inconvenience
neighbors.
• In humid locations, the unit mog sweat and
condensation
(water) mag drip from it. Take this
into consideration
when choosing the location.
• Select a location that has sufficient
ventilation.
• Do not cover the inlet and outlet.
• Install unit owog from flammable
gas or corrosive
gas leaks.
• Be sure the installation
conforms to the installation
dimension
diagram.
• Rooftop
Installations:
If the outdoor
unit is installed on a roof structure,
be sure to level the unit. Ensure the roof structure
and anchoring
method are adequate
for the unit
location. Consult local codes regarding
rooftop
mounting.
10
Advertisement
Table of Contents
