Operating Adjustments; Lubrication; Proper Operating Procedures; Adjusting Fence Indicators - Craftsman 113.27521 Operating Instructions And Parts List Manual

ADJUSTING TILT GAGE -- Using
an accurate square, set saw blade at _-L_
right angles tO table top. Then adjust
the pointer on the tilt gage (C, fig. 2)
to 0.
ADJUSTI O MITER SCALE
Using an accurate square, block the _ i_
check this cut with the square. If cut
is accurate, set the pointer on the miter
gage scale (J, fig. 2)to "90".
ADJUSTING FENCE II_
_Adjust right-hand fence indicator
(part 135, fig. 4) by positioning fence
so that it touches the right side
of the saw blade- then set indi-
qtO_S
cator at . Move fence to left
side of blade and adjust left-hand
indicator in like manner.
ADJUSTING CAM CLAMP
LEVER If clamping action of
lever (G, fig. 2) is too tight or '_!ili lid! -
too loose, it can be adjusted by in-
creasing or decreasing the effec-
tive
length of the rip fence clamp rod (part 6409, fig. 4)
This is done by readjusting the clamp rod nut (part
6407, fig. 4) on the end of the clamp rod in back of the
fence. When properly adjusted, the clamping lever
should lock in a horizontal position or slightly lower.
Figure 3
quire no additional lubrication. Other parts requiring
lubrication should be oiled frequently with SAE No. 20
or No. 30 Automobile Engine Oil. See figure 3.
1N Table trunnions m in which cradle tilts.
P Lift screw block, lift screw threads, and lift nut.
Q -- Tilt screw block, tilt screw threads, and tilt nut.
R--Friction points in saw guard.
-T S--Spindle arm pin and saw arbor housing guide
bosses.
T--Saw tilt clamp screw.
AII other points where there is friction between two
or more moving surfaces or where a slip fit is
necessary for adjustment purposes.
Special attention should be given to the moving parts
in the rip fence and miter gage.
PUSH STICK
enters the work at an angle more nearly
parallel with the direction of feed. ancl .,NO. SOUARES,
there iS better opportunity to hold the
work against kicf_back.