Instructions For Assembling And Operating Your Saw - Craftsman 113.27521 Operating Instructions And Parts List Manual

AB LE F
T D J
Figure 1
CHECK ARBOR NUT- Remove two screws (B, fig. 1)
Check tightness of
H O M and lift out the insert (A, fig. 1).
[ saw arbor nut (part 6362, fig. 5),
/ using wrench (M, fig.
1).
Re- ""--_'I
place insert and screws.
!
ALIGN SAW BLADE WITH
TABLE GROOVES- Using ele-
vation hand wheel (A, fig. 2),
set saw blade for deepest cut.
Make pencil mark on tooth that
is just above table top at front of
blade. Measure distance from this
tooth point to right-hand table
groove (L, fig. 1). Rotate blade by hand to place this
same tooth just above table top at rear then again
g measure distance from tooth point to right-hand groove.
The two measurements must be exactly equal. If not,
loosen the three screws (part S-860, fig. 4) in each trun-
nion which secure the table trunnion (part 13, fig. 4) to
the table. Shift the two trunnions until the two measure-
ments are equal, then retighten the screws. Again check
measurement.
_our
INSTALL RIP FENCE- Secure the rack (J, fig. 1) to
examine it carefully for loose
rack parallel with the top of table. Pull the rip fence knob
(G, fig 1) out to pera_it the guide of the rip fence (F,
fig. 1 ) to slide over rack ( J, fig. 1 ) then place the. rip
fence on the saw table as shown in figure 2. A shght
pressure must be exerted on the rip fence to cause it to
NOTICE
Slide fence along rack, noting clearance between fence
and table top. If any part of the fence (other than the
sliding pad at the rear) drags on the table top, or if the
clearance between fence and table varies apl_reciably as
fenc( is (j, fig. 1) must then be readjusted.
This again loosening screws (D, fig. 1)
to
;PARALLEL TO SAW
next to the right-hand
Fence
\
and
the _