Craftsman 113.251890 Owner's Manual page 19

As the carving begins to take shape some undercut
work may be necessary. This can be accomplished
by loosening two wing nuts near the yoke tilt plate,
titting the yoke assembly to the desired angle and
then re-tightening the wing nuts. "Always turn the
router off when pivoting the yoke or making any
adjustment,"
TILT PLATE
WING NUTS
After the object is nearing completion you may find
it necessary to re-mount the master and workpiece
in a vertical plane rather than horizontal. This witl
allow the bit to contact the workpiece on the top and
base sections of the carving that were inaccessible
in the horizontal plane.
{3
0
©
©
After the object has been completely carved it can
be finished in a number of ways, Some prefer the
rustic hand carved appearance that results from the
router bits while others prefer sanding by hand or
with a small hobby too[.
\
!9