Table of Contents
Advertisement
operation
With adequate eye
protection
in place,
plug the
router motor in. While holding one of the Control
knobs to insure that the bit is free of the workpiece,
turn the switch
on. Using two hands, one on the
large knob the second on the small black knob,
gently stroke the router bit into the workpiece. The
/"
stylus will guide from the master and the profile of
the
master
will soon
begin
to
appear
in the
workpiece.
After sufficient
material has been removed from the
starting position,
turn the router off, loosen the 3/8
bolt and rotate both work mounts 90° aga} n aligning
with a straight
edge. Repeat the above on all four
edges of the work mount.
After the workpiece has been rotated 360 ° remove
the large bit and step down to the next smallest
.....
diameter bit and repeat the above process. Always
re-set the elevation of the stylus in respect to the bit
_-_z,
when changing
bits.
Some
intricate
carvings
may
require
a 45 °
orientation. This can be accomplished
with the aid
of a combination
square.
Note! When carving objects which are symmetrical,
it may become difficult
to tell front from rear. You
may Wish to identify the starting edge of both work
mounts to keep them in proper relation.
\
\
\
\
BINATION
SQUARE
/
-%
\
\
\
Advertisement
Table of Contents
