Alignment; Aligning Your Router Recreator - Craftsman 113.251890 Owner's Manual

alignment
ALIGNING YOUR ROUTER RECREATOR
Proper alignment of your Router Recreator is
essential for accurate results. Although your
Recreator is designed to maintain its' alignment, it is
suggested that you check the pulley tracking and
Router/Stylus alignment not only before beginning
a project, but'occasionally during the project itself.
Remove the two Stylus Rods from the ioose parts
bag, Place the 1/4 inch end of one of the Stylus Rods
in the chuck of the router, Snug the Stylus in place
with the Router Chuck Wrench (supplied with
Router).
Place the second Stylus in the Stylus Mount. This is
done by backing off on the small black knob and
then re-tightening when the stytus is in place.
@
@
Loosen the two Tilt Plate wing nuts which will allow
the Stylus/Router Mount to pivot.
Roll the Yoke Assembly forward on the Tracks and
position the Stylus located in the Routerchuck flush
against the front face of front Shelf Board with the
chuck face resting on the edge of the shelf. Tighten
both Tilt Plate wing nuts.
t3