Craftsman 113.251890 Owner's Manual page 8

de the Pulley shaft through the bearings at the
.rear of the Y0ke Assembly followed by the shaft
Collars _ one or1 each side of the Yoke as shown,
install 1/4 inchsetsCrew in thethreaded h01e in each
of the Collars. The Collars should not be
at this time.
Slide the 5 inch Track Pulleys o n to the Pulley Shaft
with the hub of the pulley (area which contains the
setscrew) facing toward the Yoke as shown. This
Shaft shoulc_ extend beyond the Pulleys
approximately 1/8 inch on each end.
Place the pulley hubs on the Shaft such that one
pulley set screw faces front while the other faces
rear as Shown. This wil! help insure access to one of
the set screws during future adjustments.
PULLEY HUB
/
/
SHAFT SHOULD EXTEND
BEYOND PULLEYS
APPROXIMATELY 1/8"
ON EACH END
PlaCe the entire yoke assembly on the frame with the
pulleys riding on the Track Brackets and the large
black Knob facing the front.
Loosen the pulley setscrews and push outward on
the pulley so that the tracks are riding on the inside
corners of the pulley grooves as shown. Tighten the
pulley setscrews. The Pulley Shaft should extend
beyond the faces of the pulleysan equal amount on
each side,
TRACK MUST RIDE
ON INSIDE EDGE
OF PULLEY GROOVE
Iii. CABLE ASSEMBLIES
For step three you'll need --
ITEM DESCRIPTION QTY:
A Steel Cables .......................... 2
B 8-32 Hex Nuts ..................... 2
C 3/t6 X 3/8 Flat Washers ............... 2
0))))))l)))})})--
A