Advertisement
Available languages
Available languages
iNSTALL THE WHEELS ONTO THE LEGS
1.
2.
3.
4.
Use a wheel mounting
bolt (R)
and mounting
nut (S) to attach
Fig. 5
the wheel mounting
axle
assembly
(Q) on the stand.
Place the wheel
(N) on
the axle so that the axle
extends
through
the wheel
(N). Make
sure that the
molded-in
axle receptacle
shaft
on the wheel faces
the
inner clasp on the axle.
Press the wheel clasp (P) onto
the axle until you hear a click,
indicating
that it is locked into place (Fig. 5).
Repeat steps 1-3 for the other wheel.
N
MOUNTING MITER SAWS
_1_ WARNING:
Failure to unplug the tool before attaching
it to the stand could
result in accidental starting and serious personal injury.
WARNING:
To avoid serious personal injury, always make sure that miter saws
are fully supported
and securely attached to a level work surface.If necessary, move
the stand to a location where it will be more stable.
,_
WARNING:
Do not mount a table saw on this stand. The direction
of feed
on a table saw is perpendicular
the axis of stability on this stand. Aggressive
feeding of sheet materials
into a table saw could cause the stand to tip over.
Mounting Standard Miter Saws to The Stand
NOTICE: This configuration
allows for the miter saws on which the 4 mounting
holes form a rectangular pattern
(most miter saws).
1.
Mount your miter saw to
the quick-release
mounting
brackets
(B) using the miter
saw mounting
bolts (F),
washers (G), spring washers
(H) and locking nuts (I) (Fig. 6).
Page 12
16490
ManuaLRevised_12
0604
Advertisement
