Craftsman 320.16490 Operator's Manual page 14

Mounting Non=Standard Miter Saws
NOTICE: This configuration allows for miter saws on which the 4 mounting
holes holes form a trapezoid pattern (some saws) and the those on which the 3
mounting holes form a triangular pattern (few saws).
1. Place two support bars (C)
on the mounting brackets
(B). Use the support bar
mounting bolts (D), washers
(E), spring washers (H) and
locking nuts (I) to pre-tighten
the support bars (C) on the
quick-release mounting
brackets (B) (Figs. 10 and 11).
2. Position your miter saw with
non-standard mounting
holes on the cross support
bars (C). Check the position
and adjust the support bars
slowly so that the mounting
holes on the miter saw are
aligned with the slots on the
cross support bars (Fig. 12).
3. Use the miter saw mounting
bolts (F), washers (G), spring
washers (H) and locking nuts
(I) to securely tighten the saw
to the support bars (C).
4. Tighten the locking nuts (I)
to fully tighten the support
bar (C).
Fig. 10
Fig. 11
B
C
Two support bars (C) installed on mounting
brackets (B)
Fig. 12
C
Page 14 16490 Manual_Revised_12 0604